How To Remove Your Crankset

Check with the crankset manufacturer to be sure you have the correct tools for removing your crankset With the cap off pull the left crank off the spindle. Also never use a.

Pin On Park Tool

Partially tap out the axle and right-hand crank from the bottom bracket with the palm of your hand you can use a rubber mallet if its.

How to remove your crankset. Quick overview of what tools are required crank puller 14mm socket quarter and how to use them to remove a square taper crank arm from your bottom brack. That takes quite some force. Inspect your crankset to make sure its clean.

First you want to get the bike onto a bike stand or in a position where you can easily access the crankset. How to remove your crankset pictures Read More. Since most modern crankset systems contain sealed bearings you dont need to lube the area or regrease the bearings.

Three piece cranksets generally have one. To do this simply turn the pedals slowly while lifting the chain from the chainring. Crank pullers are used for the removal of basic three-piece crank types.

Use a dental pick to remove any adhesive from the. The next step would be to get the chain out of the way so you dont injure your hand. It is often easy to shift to your small gear first.

However be sure not to spray water directly at the bearing area. The arrangement of the tool parts for removal is shown next figure. Firstly remove the crank bolt with the 8mm wrench.

You should now be able to remove the crank from the axle. A little wiggle with the crank arm helps to get it loose. If it needs some encouragement gently use a rubber mallet.

How To Remove A Crank Set. Square-type spindle arms and splined-type spindle arms. Once youve broken the bolt free it will come out easily.

The spindle is held in position by bearings in the frame. Dirt and grime quickly build up and may affect your bikes performance. Remove your left crank arm from the bottom bracket.

Then tap the end of the spindle with your hand to loosen it. Simply wash the bike after each ride. The drive-side crank arm and chainrings can now be removed from the bottom bracket.

Both cranks must be removed to service or replace the bearings of a three-piece system. If playback doesnt begin shortly try restarting your device. Screw it out as far as it will go.

Pictures from how to remove your crankset. Always do this carefully you dont want to damage your bike. Cranks must be removed from the spindle to service the bottom bracket bearings or to replace the chainrings.

Turn the bolt that controls the depth of the crank pullers foot. Removal with extraction tool KF366 a two-piece tool set used with a headset bearing press. Following removal clean all remaining Loctite residue with a before reinstalling the SI circlips and bearings.

Crankset Cleaning Procedures. Both left and right cranks will have crank bolts in the arms.

Pin On Bicicleta